Kenner blaster conversion
by Arturo Delgado - TK412
first let's star with the tip part
1. cut out the orange tip
2. fit the cooper tip on the circle of the barrel of the blaster
3. put inside the cooper piece a 11/2 circle of wood with 1/2 inch in dept. drill a hole in the middle of the wood if you want the light to show
4. note i cut out part of the under pointer area in order to let the cooper piece to slide in
Magazine part
1. cut out this section where is shaded black in the blaster - then you will need to cut the shape of the magazine out of wood. then cut the shape that will fit inside.
the lenth of the wood area you will put inside is 1 1/2 inch
3. cut two shapes of the metal pieces to fit the shape of the magazine top and bottom - then drill holes to put the bolts in.